General Accessories

TTS Systems

The FT-Meter presents a lush, highly readable 2.5” meter face with calibrated scales for signal strength and discriminator reading on receive, and power output, SWR, modulation, ALC action and supply voltage on transmit.  Each function is selectable from the radio’s menu.  Easily visible from anywhere on your desk or dash, the FT-Meter is illuminated by any external 12Vdc source.  The FT-Meter comes fully assembled and ready to go, just plug it into the radio and you’re in the picture like never before.

LDG Electronics

FT-meter

For Yaesu FT-857 and FT-897

Ten-Tec Model 3003

Acro-Bat antenna hanger

The Acro-Bat is constructed from UV resistant, high-stability Trirex polycarbonate plastic to endure years of outdoor use.

 

This virtually unbreakable plastic is the same as used by electric companies for covering outdoor electric power meters. Hit it with a hammer - it won't break. All hardware included with the Acro-Bat is stainless steel for rust inhibition.Acro-Bat can be used to suspend either a ladder line-fed or small gauge RG-58 or RG8X coax-fed wire antenna. It will also accommodate ladder line itself to be used as antenna wire if desired. Pegs internal to the Acro-Bat will hold the ladder line securely in place. Internal screw connections allow solid clamping of the wire antenna to the coax or ladder line feedline itself - no soldering of ladder line or coax feedline to a wire antenna is needed. (Ladder line feed to ladder line used for antenna wire may require this).

UHF antenna base complete with 5m RG58 lead (professionally terminated)

 

Fit your own connector (which we can supply) on the end.

 

$16.00 each (inc GST)

Palstar Inc

FL30   1500W Low Pass Filter

 

Specifications:

· 1500W rating

· 70 dB attenuation above 45 MHz

· 9-pole design

LDG Electronics -  SLS-2 RJ-45 Microphone Switch

The SLS-2 is a microphone switch for modern transceivers with RJ-45 mic connectors. It features two switched and one common jack in the back; you can switch one mic between two radios, or one radio between two mics. A push-in/push-out button on the front selects the port, and an LED lights to indicate the selection. The SLS-2 runs on 12 volts DC at 100 ma from any suitable source. It makes switching radios or mics a breeze, letting you use your best mic on whichever rig you need it.

 

LDG Electronics  -   AL2K Audio/Linear/Key 2-port switch

The ALK-2 is a switch box for speakers, keying lines, ALC lines or whatever you need. It has two switched and one common set of jacks in the back: 1/8th inch stereo and RCA jacks in parallel. On the front, a push-in/push-out selects the port, and an LED lights to indicate the selection. For instance, you can switch one speaker between two radios, or two radios between one speaker.

The ALK-2 runs on 12 volts DC at 100 ma from any suitable source. It makes switching speakers or keys a breeze, letting you use whichever rig you need when you need it. You can even pre-set it, and remote control it by switching the 12 volt dc on and off from a distance.