It is almost as if Palstar designed this tuner specifically to suit Australian and New Zealand licensing rules. This unit is perfect, a safe overhead when using a 400W amplifier, a wide matching range, Multiple antenna selection and bypassing and a pleasure to operate from a most ergonomic and attractive front panel.

Specifications

· Power rating 1200 watts pep

· 160m to 20m(1200+/-j1200), 10m to 15m (1000+/-j1000)

· Output to both balanced and unbalanced lines

· Impedance matching range 20 ohms to 1200 ohms

· Easy and quick tuning with only two controls

· 6 position mode switch for multiple antennas

· Cross needle metering with backlighting (wall transformer supplied)

· Meter power range 0-300 watts / 0-3000 watts

· Differential capacitor tuning with 2 stators and 1 rotor (430pf - 19pf - 430pf@3.5kv)

· Palstar designed ceramic body roller inductor

· High power ferrite 4:1 balun

· Cross needle metering with backlighting (Requires 12VDC)

· Powder coated front panel and top cover

· Dimensions: 10 1/2" wide x 4 1/2" high x 11"deep

· Weight: 8 lbs

This tuner is built to very close tolerances. Users of balanced feeders will appreciate the feel and precision of this unit. The mechanical construction is superb.

Specifications

· Power rating 1500 watts pep

· Relay switched Hi-Z/Low-Z impedance range

· Relay switched Hi-C/Low-C variable capacitor

· Total inductance of 44uH for greater impedance range on 160m

· Matching range: 160m - 20m (2500+/-j2500)10m - 15m (1000+/-j1000)

· Band coverage from 160m to 10m

· Two silver plated ceramic body roller inductors crank handle driven

· Low minimum dual capacitance variable capacitors @960pf/65pf/4.5Kv with vernier drive for smooth accurate tuning

· Ferrite 1:1 input balun

· Peak and Peak Hold dual cross-needle metering (1-2 sec hold) with backlighting (wall transformer supplied)

· Powdercoated front panel and top cover

· Dimensions: 13" wide x 6" high x 16"deep

· Weight: 17 lbs

Specifications

· Power rating 2000 watts pep

· Impedance range 20 to 1500 Ohm 160M to 10M (assuming resistive load)

· Ferrite 4:1current balun

· Low minimum custom variable capacitors (15pf to 400pf at 4.5 kV)

· 18 uH 5 kV ceramic body roller inductor

· Silver plated inductor wheel shaft and contact wheel

· 10 uH relay switched add-on inductor for 160 Meters

· Cross-needle metering with backlighting  (12V DC supply needed)

· Powdercoated front panel and top cover

· Dimensions: 5" H x 14.5" W x 13.5" D

· Weight: 17 lbs